Rack tooth gang cutters
2021-11-06 10:30:32
jiangxingTools
3004
Rack tooth gang cutters
Rack tooth gang cutters are used on the conventional horizontal milling machines as well as on the special automatic rack milling machines. Standardized constructional dimensions therefore do not exist. The above table is intended for guidance and should facilitate the selection of milling cutter overall dimensions. The cutter width depends on the module (m) and the number of tooth rows (n)
Rack tooth gang cutters with several tooth rows for racks to module pitch
20° pressure angle, basic profile Ⅰ to Ⅱ DIN 3972
To process your order correctly, we need in addition to the gear data the required number of tooth rows on the cutter.
相關(guān)文章
- PA20° Standard Gear Milling Cutter with Module m0.4
- Advantages of high-performance gear hobs
- PA20° Standard Involute Gear Milling Cutter with Module m3.25
- Timing Pulley Hob for S.T.D MXL(2.032)
- GB Standard Gear Shaving Cutters with M2~M8
- Standard Keyway for Hobs
- PA20° Profile DIN3972 Standard Pre-grinding Gear Hob with Module m2